According to the principles of soil behavior, which Atterberg limit is defined as the moisture content at which the transition from a plastic to a liquid state occurs?
Explanation
The question asks to identify the specific Atterberg limit that corresponds to the transition of a soil's behavior from a plastic to a liquid state. The Atterberg limits (liquid limit, plastic limit, and shrinkage limit) define the boundaries between the four states of consistency of fine-grained soils: solid, semisolid, plastic, and liquid.
Other questions
In a liquid limit test using a standard grooving tool, the liquid limit is the moisture content required to close a distance of what length along the bottom of the groove after 25 blows?
What is the plasticity index (PI) of a soil with a liquid limit (LL) of 42 and a plastic limit (PL) of 18.7?
What is the shrinkage limit (SL) of a soil given the following test results: initial mass of saturated soil (M1) = 44.0 g, final mass of dry soil (M2) = 30.1 g, initial volume of saturated soil (Vi) = 24.6 cm3, final volume of dry soil (Vf) = 15.9 cm3, and density of water (rho_w) = 1 g/cm3?
If a cohesive soil has an in situ moisture content (w) of 31 percent, a liquid limit (LL) of 34.1, and a plastic limit (PL) of 12.2 percent, what is its liquidity index (LI)?
Skempton (1953) defined a quantity called activity, which is the slope of the line correlating which two soil properties?
On Casagrande's plasticity chart, what is the equation for the empirical A-line?
In the context of soil structure in cohesionless soils, which structure is characterized by particles being in stable positions, with each particle in contact with surrounding ones?
What term is used for aggregated or flocculated submicroscopic units of clay particles that can group together to form clusters?
According to the U.S. Army Corps of Engineers' empirical equation for the one-point liquid limit method, what is the value of tan(beta) that is generally used?
The plastic limit test involves rolling an ellipsoidal-sized soil mass into threads. The plastic limit is the moisture content at which the soil crumbles when the thread reaches what diameter?
What does a liquidity index (LI) greater than 1 indicate about a sensitive clay?
Which type of cohesive soil structure is formed by the settlement of individual clay particles, resulting in a more or less parallel orientation?
What is the primary cause of the cohesive nature of fine-grained soils, allowing them to be remolded without crumbling?
What is the shrinkage ratio (SR) for a soil, given that its initial volume was 24.6 cm3, its final dry volume was 15.9 cm3, and its dry mass was 30.1 g? Assume the density of water is 1.0 g/cm3.
If a soil's in situ moisture content is equal to its liquid limit, what is its consistency index (CI)?
According to the fall cone test method for determining liquid limit, the LL is the moisture content at which a standard cone penetrates what distance into the soil in 5 seconds?
What term describes the structure of relatively fine sand and silt that forms small arches with chains of particles, resulting in a large void ratio?
According to Burmister's (1949) qualitative classification, what is the description for a soil with a plasticity index (PI) between 20 and 40?
In the study of cohesive soils, what is the term for the aggregation of dispersed clay particles into visible flocs with edge-to-face contact?
What type of forces cause repulsion between two clay particles in suspension when their diffuse double layers start to interpenetrate?
According to Table 4.1, which clay mineral exhibits the highest typical liquid limit, ranging from 100 to 900?
On the plasticity chart, where do inorganic clays typically plot relative to the A-line?
What is the term for macroscopic structural features in clay soils, such as joints and fissures, that are formed from groups of clusters and can be seen without a microscope?
For the fall cone test, what is the weight of the standard cone used to determine the liquid limit?
A soil has a liquid limit of 65 and a plasticity index of 35. According to the plasticity chart, how would this soil be classified?
What happens to the diffuse double layer around clay particles when salt is added to a dispersed clay-water suspension?
If a soil's liquid limit (LL) is 35 and its plasticity index (PI) is 10, what is its plastic limit (PL)?
In the mode of packing for equal spheres, what is the approximate void ratio (e) for the very loose packing state shown in Figure 4.19a?
What is the primary difference between the nonsalt flocculation and salt flocculation structures in cohesive soils?
What does a plasticity index (PI) of 0 indicate about a soil?
If the specific gravity of soil solids (Gs) is 2.70 and the shrinkage ratio (SR) is 1.80, what is the shrinkage limit (SL) of the soil in percent?
The one-point method for determining the liquid limit generally yields good results for a number of blows (N) within which range?
According to Table 4.1, which clay mineral has the lowest typical activity value, ranging from 0.1 to 0.2?
What is the primary reason that real soils have a different range of void ratios compared to the idealized equal-spheres model?
The research by Seed, Woodward, and Lundgren (1964a) modified Skempton's definition of activity by showing that the linear relationship between plasticity index and clay-size fraction may not always do what?
What is the purpose of the U-line on the Casagrande plasticity chart?
If a soil has a liquid limit of 40 and a plastic limit of 25, what is its plasticity index (PI)?
What are the four basic states of consistency into which the behavior of a soil can be divided depending on its moisture content?
In the graphical method for estimating shrinkage limit from the plasticity chart, a line is drawn between the soil's (LL, PI) data point and which other point?
What is the term for the slope of the flow line on the semilogarithmic graph of moisture content versus number of blows in a liquid limit test?
According to the provided text, what chemical is generally used as a dispersing agent in a hydrometer test, a related procedure for fine-grained soil analysis?
In what state of consistency is a soil if its moisture content is between the shrinkage limit and the plastic limit?
What is the primary factor that causes the void ratio of real soils to increase compared to the ideal equal-spheres model?
For a soil with a liquid limit of 55 and a plasticity index of 30, would it plot above or below the A-line on the plasticity chart?
What type of soil structure can carry an ordinary static load but may break down and cause large settlement when subjected to shock loading?
According to the text, a shrinkage limit test is performed in the laboratory using a porcelain dish of about what height?
In a fall cone test for Cambridge Gault clay as shown in Figure 4.8, two different cones are used to determine the liquid and plastic limits. Which cone is heavier?
What is the relationship between the forces of attraction and repulsion when two clay particles in a dispersed suspension are very far apart?
According to Figure 4.1, which Atterberg limit marks the boundary between the solid and semisolid states of a fine-grained soil?